TUTORIAL
Measure and cut the wire 42 inches. Then, measure 10 inches from the beginning of one side, this is where you will start your DIY wire wrapped bracelet.
1
Starting from the 10 inch mark, line up the 8″ marks with each other. This will make an 8″ bracelet when finished.
2
Using your hand, or the pliers, wrap one free wire around all the other strands 3 times to create the first knot and the start of your custom bracelet.
3
Slide one bead onto the free end of the wire you just wrapped around the bracelet. Push the bead near the wrapped knot you just made on your custom bracelet. Now, wrap the free wire that the bead is on around the strands 3 times to secure it in place.
4
Pull the leftover wire you were just using and fold it over to the right to add the second bead to your custom bracelet. Again, wrap the wire around the strands 3 times. Then, add your last bead and wrap the end of the strands 3 times. Continue to wrap and make sure to tuck the wire so it won't scratch anyone's arms.
5
WELL DONE!